ImperGuard® CP | Guard Industrie

fr en nl it es

GO BACK TO LIST

Water-repellent, chloride and corrosion protection.
Compliant with Standard EN 1504-2.

A preventative and curative treatment for old concretes against ingress, chlorides, carbonation and corrosion of reinforcements.
ImperGuard^® CP is a ready to use product specially designed to repel water and reduce corrosion of existing concrete reinforcements.

Curative: It stops existing corrosion of reinforcements (within the limit of a corrosion rate of 5 microns/cm²). The corrosion rate may vary according to the humidity, amount of chlorides, etc.

Preventative: Reinforcements coming into contact with damp and chlorides (de-icing salt, etc.) oxidise causing an increase in volume which can rupture the concrete and weaken the mechanical resistance of the affected components.

In contrast to the corrosion inhibitors on the market, ImperGuard^® CP penetrates very deeply into concretes, up to 6 cm deep, and protects against damp and chlorides. ImperGuard^® CP also protects against microcracks of a maximum size of 0.3 mm.

find out more

ADVANTAGES

Protects against water, chlorides and carbonation
Reduces corrosion
Strong penetrating power up to 6 cm
Does not form a film, lets the material breathe
Invisible: does not change the colour
UV and frost resistant

USE

All types of concrete: standard, reinforced, fibre, high-performance (UHPC, GRC)
Facades
Old
External

beading effect

Compliant with Standard EN 1504-2

Effectiveness guarantee

Facades

indicative coverage

HOW TO USE

Preparing the material:

The surface must be dry, clean and free of any traces of oil, grease, curing compound, dust, efflorescence, paint and any other substance likely to compromise the correct preparation of the product.

Application:

Use the product in its pure form: do not dilute it.
Shake the packaging well before use and carry out a preliminary test.
Apply ImperGuard^® CP on the entire surface to be protected, including repaired areas.
Application is performed in 2 to 3 coats until the material is saturated depending on the material’s exposure to adverse weather conditions and harmful external factors. In exceptional cases, (tides, marine environments, etc.) application must be performed in 3 to 6 coats.
Allow at least 15 minutes between each coat, the surface must be visibly dry.
When applying with the sprayer, ensure that a mist does not form.
Drying: 24 to 72 hours.
Time before optimum effectiveness, can be covered after 15 days.

For further information, refer to the data sheet and safety sheet.

APPLICATION TOOLS

Apply using low-pressure sprayer with viton joint or airless type sprayer.